A. 8480s, CL608 and the CL612:
1. Printing a User Test Print Label.
Before getting a print out of the printer's firmware and other factory settings, you
should record the positions of the current dip switch settings so that the printer
can be returned to it's previous configuration settings. An EASY way to do this is:
a) Hold the FEED button down while powering the printer on.
b) After you hear the tone, release the FEED button.
c) The following will appear on the LCD of the printer (except the 8480s):
User Test Print
Small Large
d) You can press the LINE button to select an option. Selecting Large will print a
detailed label. See the sample on the last page. Selecting Small will also
request a size from 04cm to 16cm on the 412 or 612 (from 04cm to 10cm on the
408 or 608). Pressing the LINE button will advance the counter. This option
will only print a Print Head test pattern.
e) Press FEED to begin printing a test label.
f) Test labels will continue printing until you press the FEED button again.
2. Printing the Factory Settings Label.
a) Place Dip Switch 2-5 to the ON position. Make sure that all other dip switches
are set to the OFF position.
b) Open the Print Head.
c) While powering the printer ON, press and hold the LINE and FEED buttons.
d) When you hear the tone, release the LINE and FEED buttons.
e) Close the Print Head.
f) Flip Dip Switch 2-5 to the OFF position.
g) The following appears on the LCD display (except the 8480s):
Factory Test
h) Press the FEED button to begin printing a test label:
i) Test labels will continue printing until you press the FEED button again.
* On the 8480s, the test label will begin printing after pressing FEED. Since there
is not an LCD, you will not have a choice for which size test label to print.
B. CL408 and the CL412:
1. Printing a User Test Print Label. See 1, above. The procedure is the same.
2. Printing the Factory Settings Label.
a) Place Dip Switch 2-5 to the ON position. Make sure that all other dip switches
are set to the OFF position.
b) Open the Print Head.
c) While powering the printer ON, press and hold the LINE and FEED buttons.
d) When you hear the tone, release the LINE and FEED buttons.
e) Close the Print Head.
f) Flip Dip Switch 2-5 to the OFF position.
g) The following appears on the LCD display:
Factory Mode
h) Press the FEED button.
i) The following will appear on the LCD display:
Counter Clear
Non
j) Press the FEED button.
k) The following will appear on the LCD display:
Factory Test
l) Press the FEED button to begin printing a test label. See the sample on the
last page.
m) Test labels will continue printing until you press the FEED button again.
