|
Search:
Advanced search
|
Browse by category:
|
Sato printer using "cancel useprinter" with an incrementing/decrementing number. |
|
|
Using "cancel useprinter" in a command file with a Sato printer set for bi-directional (Status 2 or Status 4) the job gets canceled, but if there is an incrementing number on the format it is saved in the printer. Therefore, the next job that prints is a label with only the incrementing number on it.
There was a problem in the Sato firmware that caused the "cancel" command to not clear the printer's memory. Sato says that any firmware above 5.00.01.00 will correct the problem. |
|
| Others in this Category | |
| » More articles | |
Powered by
KBPublisher (Knowledge base software)

